![]() ![]() We cannot nor will not guarantee they meet any regulations out of the United States as every country has their own regulations. ![]() ***Note: These bottles are only date certed. Also, T the line going to the bottom of the wastegate and run to bottom of second wastegate. Recommended Plumbing for CO2 Wastegate Control:įor twin wastegates, simply T the line going to the top of the wastegate and run to second wastegate. (1) Adjustable CO2 Regulator with Bottle Pressure/Line Pressure Gauge.(1) Sensor T (Male, Female, Female) 1/8" NPT for Dome Pressure Sensor on Wastegate.(2) Nickel Plated Push to Connect T Fittings.(3) Straight Nickel-Plated Push to Connect 1/8" NPT Fittings.(8) 90° Nickel-Plated Push-to-Connect 1/8" NPT Fittings.This is a very standard fitting size across brands such as Tial, JGS, Precision, Turbosmart, Procharger, and many others. Our nickel-plated fittings are 1/8 NPT which work with nearly every brand wastegate, blow off valve, and solenoid on the market. The CO2 regulator comes preset at 80 psi which is appropriate for nearly every setup (the boost controller regulates pressure down from there). There are enough fittings in this kit to plumb the following: This all-inclusive kit comes with top quality fittings, regulator, line, and bottle to plumb any Boost Controller system on the market. The Motion Raceworks Twin Wastegate CO2 Kit takes the guess work out of fittings. Mount CO2 regulator as close as possible to air cylinder for proper function, any length away adds delay and possible incomplete release.Motion Raceworks TWIN Wastegate Turbocharged CO2 Kit C02 Handle Release is meant to operate at conditions of 80 psi and higher, the higher the PSI the faster and better the function of this system. Cable needs to have loose swooping bends, failure to test beforehand/and or constrictive bends can cause this handle to operate slower or incorrectly. Note: Please test operation prior to going to the racetrack. Improper Installation, hookup, or misuse may result in improper function of this part. Details Motion Raceworks Single CO2 Kit Tank comes unfilled, can’t ship filled This kit includes (6) 90 degree Nickel Plated Push To Connect 1/8 NPT (3) Straight Nickel Plated Push to Connect 1/8 NPT (1) Nickel Plate Push to Connect T (1) Sensor T (Male,Female, Female) 1/8 NPT for Dome Pressure Sensor on Wastegate (1) 2. The biggest thing is you need to TEST this before heading to the track. Please note that even though this kit is meant to be a complete kit, and has been strenuously tested, refined, and appropriately changed to work under demand of today’s chassis, care needs to be taken when installing. Our design of this kit was made to operate under 80 psi, though, it operates better the higher you go up to 120psi. When installed properly this release kit will make for simple, reliable, release of your parachute while keeping both hands firmly planted on the wheel. Available in both single and dual cable styles. ![]() We spent a ton of time designing, redesigning, and perfecting this kit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |